2007 Hyundai Santa Fe Owner's Manual - Page 112

1FEATURES OF YOUR HYUNDAI 100 To operate Compass feature Press and release the button, then the vehicle's directional heading will be displayed. Pressing and releasing the button again will turn off the display. Heading display - E : East - W : West - S : South - N : North ex) NE : North East - The compass headings are inaccurate in long distance driving. If the vehicle's compass headings become inaccurate, the compass should be calibrated as follows: 1. Ensure the vehicle is not located near large steel structures or under electric power lines. 2. Turn on the compass by pressing the button. button for more 3. Press and hold the than 6 but less than 9 seconds. The current zone number will appear in the display. Release then press the button until your zone number appears in the display. 4. Check the mirror angle by pressing and button for more than holding the 12seconds. Release then press the button to "L"(for steering wheel on the Left side of the vehicle). (if installed) 5. Press and hold the button between 9 and 12 seconds. Release the button when a "C" appears in the display. 6. Drive the vehicle in 2 complete circles at less than 5mph(8km/h) or until the compass heading appears. ! CAUTION: Be sure the area is free of traffic, pedestrians, and obstructions. Setting the compass zone 1. Determine the Zone Number based on your current location in the Zone Map. Calibration procedure If the compass is not properly calibrated, set to the correct variance zone, or the vehicle is driven in certain environments (tunnel, underground or in-building parking garage, near transformer substation), the following may occur : - "C" is displayed. - The compass heading become inaccurate. - The compass heading does not changed. - Some compass headings are not displayed. B520C06JM 2. Press and hold the button for more than 6 but less than 9 seconds. The current zone number will appear in the display. 3. Release then press the button to increment to new your zone number.