2007 Hyundai Tucson Owner's Manual - Page 140

1 FEATURES OF YOUR HYUNDAI 128 H280B01GK-GAT 1. Power Button (POWER ON) Press this button when the ignition switch of the automobile is set to ACC (1st notch) or ON (2nd notch) to turn on the power and the audio system. Press once again when the audio system is on to turn off the power. 5. Automatic Channel Selection Button (SEEK) Press the upper side of the button to automatically increase frequency and select and play the receivable channel. Press the lower side of the button to automatically decrease frequency and select and play the next available channel. BASS Turn the TUNE Controller clockwise to increase bass tone and counterclockwise to decrease. Turn the TUNE Controller clockwise to increase middle tone and counterclockwise to decrease. Turn the TUNE Controller clockwise to increase treble tone and counterclockwise to decrease. Turn the TUNE Controller clockwise to increase right speaker volume and counterclockwise to increase left speaker volume. Turn the TUNE Controller clockwise to increase rear speaker volume and counterclockwise to increase front speaker volume. MIDDLE 2. Volume Control (VOLUME) Turn the volume control clockwise to increase volume and counterclockwise to reduce. The volume level will be displayed on the screen when you adjust the volume. 6. Preset Button (1~6) Press this button to listen to the channels memorized to each button. If you want to memorize the current channel to the preset button, press the button for more than 1.5 seconds then the channel will be memorized to the button with a beep. TREBLE 3. Radio Band Selection Button (FM/AM) o Press this button to listen to either FM or AM. o The radio will be set to each of the following modes each time you press the button. FM1 ➟ FM2 ➟ AM BALANCE 7. Information Display Screen (LCD) A variety of information will be displayed on the screen including the radio bands (FM1/FM2/ AM) while listening to the radio, frequency of each channel, the number of preset channel and "ST" for FM stereo broadcasting. NOTE: Push this button when the power is off to turn on the power automatically. FADER 4. SCAN Button Press this button to automatically select channels starting from the current channel and play each channel for 5 seconds (American Standard). 8. AUDIO Select Button Press this button to control tone. Each time you press the button, the mode will switch from BASS ➟ MIDDLE ➟ TREBLE ➟ FADER ➟ BALANCE and the mode will be displayed on the screen.