2008 Hyundai Elantra Owner's Manual - Page 200

Features of your vehicle 1. XM Selector • This is XM selector and it will turn to each mode in the following order each time you press the button. - XM1 XM2 XM3 • When you press this button when you are listening to CD or RADIO, the system will automatically turn to XM mode. • When ignition switch of the automobile is set to ACC (1st notch) or ON (2nd notch) and when you press this button, XM will be on even when the audio system was turned off. 3. SCAN Button When you press this button, the player will play 10 seconds of each channel (LCD will display "SCAN"). Press it again to cancel scanning. Also, press and this button for more than 0.8 seconds to play the channels memorized to the preset buttons for 10 seconds each. (LCD will display "corresponding channel number", "", and "SCAN".) Press it again to cancel scanning. 5. Channel Move (Seek Up/Down) Button • When you press this button, the channel will move automatically and stop at the next available channel and play the channel. The display will cycle once through the Channel, Title, Name and Category for selected channel. (Press [ ] to move to the higher frequencies, press [ ] to the lower frequencies automatically.) Press and hold either the down or up at a fast rate. The display will show the Channel Name and Number while tuning at the fast rate. • Radio ID :Seek or tune to XM channel 0 to display the Radio ID. 4. Information Button You can see the information of the channel currently received and you can switch to different information by pressing this button in the following order. - Title Name Category Current State 2. LCD (Liquid Crystal Display) It displays the XM1, XM2, XM3, Preset Number, Title of the Channel Received, EQ Mode (CLASSIC, POP, ROCK, JAZZ), and SCAN Status when listening to XM. 6. Preset Memory Button Press this button and hold for less than 0.8 seconds to listen to the channel memorized to the button. Also, when you are listening to the channel other than the channel memorized to the button using TUNE or SEEK, press the button you wish to memorize current channel to and hold for more than 0.8 seconds until it beeps to memorize the channel. 4 127