2008 Hyundai Tiburon Owner's Manual - Page 178

3 WHAT TO DO IN AN EMERGENCY 12 D060C01A-AAT D060D02A-AAT 2. Block the Wheel Flat tire 3. Loosen Wheel Nuts HGK4009 The jack is located behind the right side luggage trim. Remove the jack cover by unscrewing the bolts. Turn the jack end counterclockwise to lower the jack height by using a screw driver or wrench bar and remove it from the bracket. HGK4011 HGK4013 Block the wheel that is diagonally opposite from the flat to keep the vehicle from rolling when the car is raised on the jack. The wheel nuts should be loosened slightly before raising the car. To loosen the nuts, turn the wrench handle counterclockwise. When doing this, be sure that the socket is seated completely over the nut so it cannot slip off. For maximum leverage, position the wrench so the handle is to the left as shown in the drawing. Then, while holding the wrench near the end of the handle, push down on it with steady pressure. Do not remove the nuts at this time. Just loosen them about one-half turn.