2008 Hyundai Tiburon Owner's Manual - Page 21

FEATURES OF YOUR HYUNDAI 1 9 POWER WINDOW B070E02GK-GAT B050A02GK-AAT Replacing the battery When the transmitter's battery begins to get weak, it may take several pushes on the button to lock or unlock the doors, and the LED will not light. Replace the battery as soon as possible. Battery type : CR2016 Replacement instructions: (2) OGK016121 HGK2015 Battery (1) 2. Remove the old battery from the case and note the polarity. Make sure the polarity of the new battery is the same(+side facing up), then insert it in the transmitter. NOTE: Screwdriver OGK016122 Install a new battery within 30 seconds after removing the old one. If installing a new battery takes more than 30 seconds, take the following steps. 1) Turn the ignition key to the "ACC" position. 2) Make sure that the turn signal lamps blink once by pushing the "LOCK" or "UNLOCK" button on the transmitter. 1. Carefully separate the case with a blade screwdriver as shown in the illustration. The power windows operate only when the ignition key is in the "ON" position. The main switches are located on the driver's arm rest and control the front windows on the respective sides of the vehicle. The windows may be opened by depressing the front portion of the switch. To stop at the desired opening, release the switch. The window may be closed by pulling the front portion of the switch. To open the window on the driver's side, press the switch(1) halfway down. The window moves as long as the switch is operated. To fully open the driver's window automatically, press the switch fully down. In automatic operation, the window will fully open even if you let go of the switch.