2010 Hyundai Accent Owner's Manual - Page 18

FEATURES OF YOUR HYUNDAI 1 7 7 o The driver's door can be opened by pulling the inside door handle even if the front portion of the central door locking switch has been depressed to lock the doors. o If the door is locked/unlocked multiple times in rapid succession with either the vehicle key or door lock switch, the system may stop operating temporarily in order to protect the circuit and prevent damage to system components. o The central door locking is operated by turning the key in the driver's door lock toward the front or rear of the vehicle. B070F03O-AAT KEYLESS ENTRY SYSTEM (If Installed) This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. 3. At the same time all doors lock, the turn signal light will blink once to indicate that the system is locked. Unlocking doors 1. Push the "UNLOCK" button on the transmitter. 2. Two turn unlock mode At the same time the driver's door unlocks, the turn signal light will blink twice to indicate that the system is unlocked. If you wish to unlock all doors, press the "UNLOCK" button on the transmitter again within 4 seconds. Central door unlock mode (If Installed) At the same time all doors unlock, the turn signal light will blink twice to indicate that the system is unlocked. ! WARNING: ! WARNING: Be careful not to pull the inside door handle while driving. If you pull the inside door handle, the door can be opened and you may be ejected from the vehicle and can be injured or killed. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. If the keyless entry system is inoperative due to changes or modifications not expressly approved by the party responsible for compliance, it will not be covered by your manufacturer's vehicle warranty. NOTE: Unlock mode conversion (two turn unlock mode ↔ central door unlock mode) (If Installed) The unlock mode is changed alternately by pressing the lock button and unlock button at the same time for 4 seconds or more. The turn signal light will blink four times to indicate that the mode conversion is completed. Locking doors 1. Close all doors. 2. Push the "LOCK" button on the transmitter.