2012 Hyundai Elantra Owner's Manual - Page 283

What to do in an emergency ✽ NOTE The pressure gauge may show higher than actual reading when the compressor is running. To get an accurate tire reading, the compressor needs to be turned off. - To reduce the inflation pressure: Press the button (8) on the compressor. Distributing the sealant 11. Immediately drive approximately 2 miles (3 km) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 50mph (80 km/h). If possible, do not fall below a speed of 12 mph (20 km/h). While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive with caution until you can safely pull off of the side of the road. Call for road side service or towing. Setting the tire inflation pressure 12. After driving approximately 2 miles (3 km), stop at a suitable location. 13. Connect connection hose (9) of the compressor directly to the tire valve. 14. Connect between compressor and the vehicle power outlet using the cable and connectors. 15. Adjust the tire inflation pressure to 32 psi (220 kPa). With the ignition switched on, proceed as follows. - To increase the inflation pressure: Switch on the compressor, position I. To check the current inflation pressure setting, briefly switch off the compressor. CAUTION Be careful not to overinflate the tire and stay away from the tire when filling it. 16. Remove the speed restriction label(0) from the sealant bottle(1) and place it in a highly visible place in the vehicle such as on the steering wheel to remind you not to drive too fast. WARNING Do not let the compressor run for more than 10 minutes, otherwise the device will overheat and may be damaged. 6 24