2013 Hyundai Sonata Owner's Manual - Page 128

Features of your vehicle Reprogramming a single HomeLink® button To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps: 1. Press and hold the desired HomeLink® button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed with "Programming" step 2. For questions or comments, contact HomeLink® at www.homelink.com or 1800-355-3515. Erasing HomeLink® buttons Individual buttons cannot be erased. However, to erase all three programmed buttons: 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flashafter 10 seconds. 2. Release both buttons. Do not hold for longer than 20 seconds. The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above. FCC ID: NZLTLMHL4 IC: 4112A-TLMHL4 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. CAUTION The transceiver has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device. NVS® is a registered trademark and ZNav™ is a trademark of the Gentex Corporation, Zeeland, Michigan. HomeLink® is a registered trademark owned by Johnson Controls, Incorporated, Milwaukee, Wisconsin. 4 47