2007 Infiniti M35 Owner's Manual - Page 124
2007 Infiniti M35 Manual
Page 124 highlights
second person to assist when performing this step. 7. Quickly (within 30 seconds of pushing and releasing the garage door opener training button) and firmly push and release the HomeLink button you've just programmed. Push and release the HomeLink button up to three times to complete the training. 8. Your HomeLink button should now be programmed. To program the remaining HomeLink buttons for additional door or gate openers, follow steps 2 through 8 only. NOTE: Do not repeat step one unless you want to "clear" all previously programmed HomeLink buttons). If you have any questions or are having difficulty programming your HomeLink buttons, please refer to the HomeLink web site at: www.homelink.com or call 1-800-355-3515. PROGRAMMING HomeLink FOR CANADIAN CUSTOMERS Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink , continue to push and hold the HomeLink button (note steps 2 through 4 under "Programming HomeLink ") while you push and re-push ("cycle") your handheld transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming). NOTE: If programming a garage door opener, etc., it is advised to unplug the device during the "cycling" process to prevent possible damage to the garage door opener components. while the signal is being transmitted. PROGRAMMING TROUBLE DIAGNOSIS If HomeLink does not quickly learn the hand-held transmitter information: replace the hand-held transmitter batteries with new batteries. position the hand-held transmitter with its battery area facing away from the HomeLink surface. push and hold both the HomeLink and hand-held transmitter buttons without interruption. position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the INFINITI Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner's Manual. OPERATING HomeLink UNIVERSAL TRANSCEIVER HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink Universal Transceiver button. The red indicator light will illuminate 2-54 Instruments and controls