2007 Infiniti M35 Owner's Manual - Page 153
2007 Infiniti M35 Manual
Page 153 highlights
Repeat the above procedure to adjust the right mirror position and store in the selected memory. When the driver's seat, outside mirror and steering column are not in the memorized position, the outside mirror will move with the initial tiltdown angle, if the reverse tilt-down position is stored. the memorized position. Confirming memory storage Push the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds. If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In this case, reset the desired position using the previous procedure. If optional Intelligent Keys are added to your vehicle, the memory storage procedure to switch 1 or 2 and linking Intelligent Key procedure to a stored memory position should be performed again for each Intelligent Key. For additional Intelligent Key information, see "Key (Intelligent Key)" earlier in this section. 2. Push the ignition switch to the ON position. 3. Push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, steering column and outside mirrors will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds. Linking Intelligent Key to a stored memory position The Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 seconds, push the button on the Intelligent Key. The indicator light will blink. After the indicator light goes off, the Intelligent Key is linked to that memory setting. Push the ignition switch to the LOCK position and press the button on the Intelligent Key. The driver's seat, steering wheel and outside mirrors will move to SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: When the vehicle speed is above 4 MPH (7 km/h). When the adjusting switch for the driver's seat and steering column is turned on while the automatic drive positioner is operating. When the memory switch 1 or 2 is not pushed for at least 1 second. When the seat has already been moved to the memorized position. When no seat position is stored in the memory switch. When the engine is started while mov- Selecting the memorized position 1. Set the selector lever to the P (Park) position. Pre-driving checks and adjustments 3-27