2007 Infiniti M35 Owner's Manual - Page 241
2007 Infiniti M35 Manual
Page 241 highlights
PUSH-BUTTON IGNITION SWITCH WARNING For AWD equipped vehicles, do not attempt to raise two wheels off the ground and shift the transmission to any D (Drive) or R (Reverse) position with the engine running. Doing so may result in drivetrain damage or unexpected vehicle movement which could result in serious vehicle damage or personal injury. Do not attemp to test an AWD equipped vehicle on a 2-wheel dynamometer, (such as dynamometers used by some states for emission testing), or similar equipment even if the other two wheels are raised off the ground. Make sure you inform the test facility personnel that your vehicle is equipped with AWD before it is placed on a dynamometer. Using the wrong test equipment may result in drivetrain damage or unexpected vehicle movement which could result in serious vehicle damage or personal injury. When a wheel is off the ground due to an unlevel surface, do not spin the wheel excessively. Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times or the ignition switch is pushed and held for more than 2 seconds.) CAUTION When the battery of the Intelligent Key runs down, insert the Intelligent Key into the Intelligent Key port until a click sounds. And then, push the ignition switch to start the engine. If the steering lock release malfunction indicator appears on the dot matrix liquid crystal display, push the pushbutton ignition switch again while lightly turning the steering wheel right and left. See "Dot matrix liquid crystal display" in the "2. Instruments and controls" section. SSD0519 When the ignition switch is pushed without depressing the brake pedal, the ignition switch position will illuminate as follows: Push center once to change to ACC. two times to change to ON. three times to return to LOCK. The ignition switch is equipped with an anti-theft steering lock device. The ignition lock is designed so that the ignition switch position cannot be switched to LOCK until the selector lever is moved to the P (Park) position. Starting and driving 5-7