2007 Infiniti M35 Owner's Manual - Page 259
2007 Infiniti M35 Manual
Page 259 highlights
eling ahead. The sensor generally detects the signals returned from the reflectors on a vehicle ahead. Therefore, if the sensor cannot detect the reflector on the vehicle ahead, the ICC system may not maintain the selected distance. The following are some conditions in which the sensor cannot detect the signals: When the reflector of the vehicle ahead is positioned high on the vehicle (trailer, etc.) SSD0455 When your vehicle is towing a trailer, etc. The ICC system is designed to automatically check the sensor's operation. When the sensor is covered with dirt or obstructs, the system will automatically be canceled. If the sensor is covered with ice, a transparent or translucent vinyl bag, etc., the ICC system may not detect them. In these instances, the vehicle-tovehicle distance control mode may not cancel and may not be able to maintain the selected following distance from the vehicle ahead. Be sure to check and clean the sensor regularly. The vehicle-to-vehicle distance control mode is designed to maintain a selected distance and reduce the speed to match the slower vehicle ahead; the system will decelerate the vehicle as necessary. However, the ICC system can only apply up to 25% of the vehicles total braking power. This system should only be used when traffic conditions allow vehicle speeds to remain fairly constant or when vehicle speeds change gradually. If a vehicle moves into the traveling lane ahead or if a vehicle traveling ahead rapidly decelerates, the distance between vehicles may become closer because the ICC system VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE OPERATION Always pay attention to the operation of the vehicle and be ready to manually control the proper following distance. The vehicle-to-vehicle distance control mode of the Intelligent Cruise Control (ICC) system may not be able to maintain the selected distance between vehicles (following distance) or selected vehicle speed under some circumstances. The vehicle-to-vehicle distance control A mode uses a sensor k located on the front of the vehicle to detect vehicles trav- When the reflector on the vehicle ahead is missing, damaged or covered When the reflector of the vehicle ahead is covered with dirt, snow and road spray When the snow or road spray from traveling vehicles reduces the sensor's visibility When dense exhaust or other smoke (black smoke) from vehicles reduces the sensor's visibility When excessively heavy baggage is loaded in the rear seat or the trunk of your vehicle Starting and driving 5-25