2007 Infiniti M35 Owner's Manual - Page 370
2007 Infiniti M35 Manual
Page 370 highlights
INSTALLING FRONT LICENSE PLATE Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag. Only use the recommended mounting position or Intelligent Cruise Control (ICC) sensor obstruction (if so equipped) may result. License plate bracket J-nut x 2 Screw x 2 Screw grommet x 2 1. Temporarily place the license plate A bracket while aligning part k of the B front bumper with part k of the rear surface of the license plate bracket. 2. To determine where to drill the hole, mark along both sides of the mounting hole by using a felt-tip pen. 3. Remove the license plate bracket and connect the arcs to form ovals. Mark the point in the center of each oval. These are the pilot drilling locations. STI0419 4. Carefully drill two pilot holes using a 0.39 in (10 mm) drill bit at the marked 9-12 Technical and consumer information