2010 Jeep Patriot Owner's Manual - Page 158

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157 Programming HomeLink Before You Begin If you have not trained any of the HomeLink buttons, erase all channels before you begin training. 3. Simultaneously press and hold both the chosen HomeLink button and the handheld transmitter button To do this, press and hold the two outside buttons for until the HomeLink indicator changes from a slow to a 20 seconds until the red indicator flashes. rapidly blinking light, then release both the HomeLink It is recommended that a new battery be placed in the and handheld transmitter buttons. handheld transmitter of the device that is being copied to Watch for the HomeLink indicator to change flash rates. HomeLink for more efficient training and accurate When it changes, it is programmed. It may take up to transmission of the radio-frequency signal. 30 seconds or longer in rare cases. The garage door may Your vehicle should be parked outside of the garage open and close while you train. when programming. NOTE: • Some gate operators and garage door openers may 1. Turn the ignition switch to the ON/RUN position. require you to replace Step 3 with procedures noted in 2. Hold the battery side of the handheld transmitter the "Gate Operator/Canadian Programming" section. away from the HomeLink button you wish to program. Place the handheld transmitter 1-3 in (3-8 cm) away from the HomeLink button you wish to program while keeping the indicator light in view. 3