2010 Jeep Patriot Owner's Manual - Page 161
2010 Jeep Patriot Manual
Page 161 highlights
160 UNDERSTANDING THE FEATURES OF YOUR VEHICLE If you unplugged the device for training, plug it back in 2. Press and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not at this time. release the button. Then proceed with Step 4 under "Programming 3. Without releasing the button, proceed with ProgramHomeLink " earlier in this section. ming HomeLink Step 2 and follow all remaining steps. Using HomeLink To operate, press and release the programmed Security HomeLink button. Activation will now occur for the It is advised to erase all channels before you sell or turn trained device (i.e., garage door opener, gate operator, in your vehicle. Security system, entry door lock, home/office lighting, To do this, press and hold the two outside buttons for etc.,). The handheld transmitter of the device may also be 20 seconds until the red indicator flashes. Note that all used at any time. channels will be erased. Individual channels cannot be Reprogramming A Single HomeLink Button erased. To reprogram a channel that has been previously trained, The HomeLink Universal Transceiver is disabled when follow these steps: the Vehicle Security Alarm is active. 1. Turn the ignition switch to the ON/RUN position.