2010 Jeep Patriot Owner's Manual - Page 17
2010 Jeep Patriot Manual
Page 17 highlights
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE dealer or by following the customer key programming seconds, but no longer than 15 seconds. Then, turn the procedure. This procedure consists of programming a ignition switch to the LOCK position and remove the first blank key to the vehicle electronics. A blank key is one key. that has never been programmed. 3. Insert the second valid key into the ignition switch. NOTE: When having the Sentry Key Immobilizer Turn the ignition switch to the ON position within System serviced, bring all vehicle keys with you to an 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. authorized dealer. Turn the ignition switch to the LOCK position and Customer Key Programming remove the second key. If you have two valid Sentry Keys , you can program new Sentry Keys to the system by performing the 4. Insert a blank Sentry Key into the ignition switch. following procedure: Turn the ignition switch to the ON position within 60 seconds. After 10 seconds, a single chime will sound. 1. Cut the additional Sentry Key Transponder blank(s) In addition, the Vehicle Security Light will stop flashing. to match the ignition switch lock cylinder key code. To indicate that programming is complete, the Vehicle 2. Insert the first valid key into the ignition switch. Turn Security Light will turn on again for three seconds and the ignition switch to the ON position for at least three then turn off.