2010 Jeep Patriot Owner's Manual - Page 190

UNDERSTANDING YOUR INSTRUMENT PANEL 189 INSTRUMENT CLUSTER DESCRIPTIONS 1. Fuel Gauge/Fuel Door Reminder When the ignition switch is in the ON position, 3. Electronic Throttle Control (ETC) Light This light informs you of a problem with the the pointer will show the level of fuel remainElectronic Throttle Control (ETC) system. If a ing in the fuel tank. The fuel pump symbol problem is detected, the light will come on points to the side of the vehicle where the fuel while the engine is running. Cycle the ignition door is located. key when the vehicle has completely stopped and the 2. Charging System Light shift lever is placed in the NEUTRAL position. The light This light shows the status of the electrical chargshould turn off. If the light remains lit with the engine ing system. The light should come on when the running, your vehicle will usually be drivable; however, ignition switch is first turned ON and remain on briefly see an authorized dealer for service as soon as possible. If as a bulb check. If the light stays on or comes on while the light is flashing when the engine is running, immedriving, turn off some of the vehicle's non-essential diate service is required and you may experience reduced electrical devices or increase engine speed (if at idle). If performance, an elevated/rough idle or engine stall and the charging system light remains on, it means that the your vehicle may require towing. The light will come on vehicle is experiencing a problem with the charging when the ignition is first turned ON and remain on system. Obtain SERVICE IMMEDIATELY. See an authorized dealer. If jump starting is required, refer to "Jump Starting Procedures" in "What To Do In Emergencies". 4