2010 Jeep Patriot Owner's Manual - Page 200
2010 Jeep Patriot Manual
Page 200 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 199 Lo tIrE When tire pressure is low, the odometer display will toggle between Lo and tIrE for three cycles. CHAngE OIL Message Your vehicle is equipped with an engine oil change indicator system. The "CHAngE OIL" message will flash in the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure: 1. Turn the ignition switch to the ON position. Do not start the engine. 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition switch to the OFF/LOCK position. NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary repeat this procedure. 24. OFF ROAD Indicator - If Equipped The symbol illuminates (is armed) when the 4WD lock switch is activated and the shift lever is in LOW or REVERSE position. 25. Malfunction Indicator Light (MIL) The Malfunction Indicator Light (MIL) is part of an Onboard Diagnostic system called OBD II that monitors emissions, engine, and automatic transmission control systems. The light will illuminate when 4