2010 Jeep Patriot Owner's Manual - Page 292
2010 Jeep Patriot Manual
Page 292 highlights
STARTING AND OPERATING 291 Tip Start Do not press the accelerator. Turn the ignition switch to the START position and release it as soon as the starter engages. The starter motor will continue to run, and it will disengage automatically when the engine is running. If the engine fails to start, the starter will disengage automatically in 10 seconds. If this occurs, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the "Normal Starting" procedure. WARNING! Do not attempt to push or tow your vehicle to get it started. Vehicles equipped with an automatic transmission cannot be started this way. Unburned fuel could enter the catalytic converter and once the engine has started, ignite and damage the converter and vehicle. If the vehicle has a discharged battery, booster cables may be used to obtain a start from another vehicle. This type of start can be dangerous if done improperly, so follow the procedure carefully. Refer to "Jump Starting" in "What To Do In Emergencies" for further information. Normal Starting Normal starting of either a cold or a warm engine does not require pumping or pressing the accelerator pedal. Simply turn the ignition switch to the START position and release when the engine starts. If the engine fails to Extreme Cold Weather (Below 20°F Or 29°C) start within 15 seconds, turn the ignition switch to the To ensure reliable starting at these temperatures, use of OFF position, wait 10 to 15 seconds, then repeat the an externally powered electric engine block heater (avail"Normal Starting" procedure. able from your authorized dealer) is recommended. 5