2010 Jeep Patriot Owner's Manual - Page 405
2010 Jeep Patriot Manual
Page 405 highlights
404 MAINTAINING YOUR VEHICLE persists, the message will appear the next time the vehicle is started. This might indicate a damaged cap. If the problem is detected twice in a row, the system will turn on the MIL. Resolving the problem will turn the MIL light off. EMISSIONS INSPECTION AND MAINTENANCE PROGRAMS In some localities, it may be a legal requirement to pass an inspection of your vehicle's emissions control system. Failure to pass could prevent vehicle registration. Normally, the OBD II system will be ready. The OBD II system may not be ready if your vehicle was recently serviced, recently had a dead battery or a battery replacement. If the OBD II system should be determined not ready for the I/M test, your vehicle may fail the test. Your vehicle has a simple ignition key-actuated test, which you can use prior to going to the test station. To check if your vehicle's OBD II system is ready, you must do the following: 1. Turn the ignition switch to the ON position, but do not For states that require an Inspection and Mainte- crank or start the engine. nance (I/M), this check verifies the "Malfunction 2. If you crank or start the engine, you will have to start Indicator Light (MIL)" is functioning and is not this test over. on when the engine is running, and that the OBD II 3. As soon as you turn the ignition switch to the ON system is ready for testing. position, you will see the MIL symbol come on as part of a normal bulb check.