2004 Lexus RX 330 Owners Manual - Page 562

DRIVING TIPS Trailer lights Maintenance D If you tow a trailer, your vehicle will require more frequent maintenance due to the additional load. For this information, please refer to the scheduled maintenance information in the "Owner's Manual Supplement / Scheduled Maintenance". D Retighten all fixing bolts of the towing ball and bracket after approximately 1000 km (600 miles) of trailer driving. Connecting a trailer (models with electronically modulated air suspension) Stop your vehicle and a trailer in line and perform the following: " Socket for trailer lights Your vehicle is equipped with a wire harness stored in the rear end underbody. Models with tow hitch receiver are fitted with a socket for trailer lights under the rear bumper. Use either of them to connect and operate the trailer lights. However, the trailer lights must comply with federal, state/provincial and local regulations. See your local recreational vehicle dealer or rental agency for the correct type of wiring and relays for your trailer. Check for correct operation of the turn signals and stop lights each time you hitch up. Direct splicing may damage your vehicle's electrical system and cause a malfunction of your lights. 1. Put the electronically modulated air suspension in the "LO" mode. Turn the ignition switch off or push the height control switch to turn off the electronically modulated air suspension. 2. Connect a trailer. 3. Turn the ignition switch on or push the height control switch to turn on the electronically modulated air suspension. Select the "N" (normal) mode with the height select switch. Break-in schedule D Lexus recommends that you do not tow a trailer with a new vehicle or a vehicle with any new power train component (engine, transmission, differential, wheel bearing, etc.) for the first 800 km (500 miles) of driving. 539