1998 Lincoln Navigator Owner's Manual - Page 145

Maintenance and care 5. If the fluid is low, add fluid in small amounts, continuously checking the level until it reaches the range between the MIN and MAX lines. Be sure to put the cap back on the reservoir. TRANSMISSION FLUID Checking and adding automatic transmission fluid Follow the scheduled service intervals outlined in the "Service Guide." Before adding any fluid, make sure the correct type is used. The type of fluid used is normally indicated on the dipstick and/or dipstick handle and also in the Lubricant specifications section in the Capacities and specifications chapter. An overfill condition of transmission fluid may cause shift and/or engagement concerns and/or possible damage. Do not drive the vehicle if the fluid level is below the COLD (C) area on ADD COLD HOT DO NOT ADD the dipstick and outside temperatures are above 10°C (50°F) (see figure to the right). Your transmission does not use up fluid. However, it is recommended that you check the transmission fluid at least twice a year. The fluid level should be checked if the transmission is not working properly, i.e., if the transmission slips or shifts slowly or if you notice some sign of fluid leakage. Transmission fluid should be checked at normal operating temperatures 66°C-77°C (150°F-170°F) on a level surface. The normal operating temperature can be reached after approximately 32 km (20 miles) of driving. The transmission fluid should be in this range if at normal operating ADD COLD HOT DO NOT ADD temperature (66°C-77°C [150°F-170°F]) (see figure to the right). 145