2007 Lincoln MKX Owner's Manual - Page 91

Driver Controls Gate Operator & Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting - not allowing enough time for HomeLink to accept the signal from the hand-held transmitter. After completing Steps 1 and 2 outlined in the "Programming" section, replace Step 3 with the following: Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent overheating. • Continue to press and hold the HomeLink button (note Step 3 in the "Programming" section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink . The indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. • Proceed with Step 4 in the "Programming" section. Operating the HomeLink Wireless Control System To operate, simply press and release the appropriate HomeLink button. Activation will now occur for the trained product (garage door, gate operator, security system, entry door lock, or home or office lighting etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties, contact HomeLink at www.homelink.com or 1-800-355-3515. 91 2007 MKX (mkx) Owners Guide (post-2002-fmt) USA (fus)