2003 Mazda MAZDA6 Owner's Manual - Page 138
2003 Mazda MAZDA6 Manual
Page 138 highlights
shuseizumi_J56J_8R29_EA_02I.book Page 44 Wednesday, October 16, 2002 9:51 AM Driving Your Mazda Switches and Controls M Programming the HomeLink System CAUTION The transceiver has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device. NOTE CAUTION When programming a garage door opener or a gate, disconnect the power to these devices before performing programming, as continuous operation of the devices could damage the motor. The HomeLink system provides 3 buttons which can be individually selected and programmed using the transmitters for current, on-market devices as follows: 1. Verify that there is a remote control transmitter available for the device you would like to program. 2. Disconnect the power to the device. 3. Hold the transmitter for the device to be programmed in close proximity to HomeLink, approximately 2.5-7.5 cm (1-3 in). 4. Press the transmitter button and the desired HomeLink button simultaneously until the HomeLink indicator light goes from slow to rapid flashing. 5. Connect the power to the device. 6. Verify that the device operates properly by pressing the HomeLink button that was programmed. FCC ID: NZLSTDHL3 CANADA: 4112104541A This device complies with FCC rules part 15. Operation is subject to the following conditions: 1- This device may not cause any harmful interference and 2- This device must accept any interference that may be received including interference that may cause undesired operation. NOTE The programming will not be erased even if the battery is disconnected. 5-44 Form No. 8R29-EA-02I