2003 Mazda MAZDA6 Owner's Manual - Page 97
2003 Mazda MAZDA6 Manual
Page 97 highlights
shuseizumi_J56J_8R29_EA_02I.book Page 3 Wednesday, October 16, 2002 9:51 AM Driving Your Mazda Starting and Driving Starting the Engine NOTE NOTE If turning the key is difficult, jiggle the steering wheel from side to side. ACC (Accessory) The steering wheel unlocks and some electrical accessories will operate. ON This is the normal running position after the engine is started. The warning lights (except brakes) should be inspected before the engine is started (page 5-27). NOTE Engine-starting is controlled by the spark ignition system. This system meets all Canadian Interference-Causing Equipment Standard requirements regulating the impulse electrical field strength of radio noise. 1. Occupants should fasten their seat belts. 2. Make sure the parking brake is on. 3. Depress the brake pedal. 4. (Manual transaxle) Depress the clutch pedal all the way and shift into neutral. Keep the pedal depressed while cranking the engine. NOTE When the ignition switch is turned to the ON position, the sound of the fuel pump motor operating near the fuel tank can be heard. This does not indicate an abnormality. START The engine is started in this position. It will crank until you release the key; then it returns to the ON position. The brake warning light can be checked after the engine is started (page 5-27). The starter will not operate if the clutch pedal is not pushed down all the way. (Automatic transaxle) Put the vehicle in park (P). If you must restart the engine while the vehicle is moving, shift into neutral (N). NOTE M Ignition Key Reminder If the ignition switch is in the LOCK or ACC position, a beep will sound when the driver's door is opened. The starter will not operate if the shift lever is not in P or N. 5-3 Form No. 8R29-EA-02I