2004 Mazda MPV Owner's Manual - Page 141

Driving Your Mazda Starting and Driving Ignition Switch M Ignition Switch Positions NOTE If turning the key is difficult, jiggle the steering wheel from side to side. ACC (Accessory) The steering wheel unlocks and some electrical accessories will operate. ON This is the normal running position after the engine is started. The warning lights (except brakes) should be inspected before the engine is started (page 5-24). LOCK The steering wheel locks to protect against theft. Only in this position can the key be removed. NOTE WARNING Removing the Key: It's dangerous to remove the key from the ignition switch while the vehicle is moving. Removing the key allows the steering wheel to lock. You will lose steering control and a serious accident could occur. Remove the key only when the vehicle is parked. Not Setting the Parking Brake: Leaving the driver's seat without setting the parking brake is dangerous. Unexpected vehicle movement could occur if the parking brake is not set. This could cause an accident. Before leaving the driver's seat, always set the parking brake and make sure the shift lever is in P. When the ignition switch is turned to the ON position, the sound of the fuel pump motor operating near the fuel tank can be heard. This does not indicate an abnormality. START The engine is started in this position. It will crank until you release the key; then it returns to the ON position. The brake warning light can be checked after the engine is started (page 5-24). M Ignition Key Reminder If the ignition switch is in the LOCK or ACC position, a beep sound will be heard when the driver's door is opened. 5-2