2004 Mazda Tribute Owner's Manual - Page 100

Seating and Safety Restraints all automatic locking retractors on all outboard seating positions as well as the automatic locking mode for child safety seats on the passenger front belt. All safety belt assemblies, including retractors, buckles, front seat belt buckle assemblies, buckle support assemblies (slide bar-if equipped), shoulder belt height adjusters (if equipped), shoulder belt guide on seatback (if equipped), child safety seat tether bracket assemblies (if equipped), LATCH child seat tether anchors and lower anchors (if equipped), and attaching hardware, should be inspected after a collision. Mazda recommends that all safety belt assemblies used in vehicles involved in a collision be replaced. However, if the collision was minor and an authorized Mazda technician finds that the belts do not show damage and continue to operate properly, they do not need to be replaced. Safety belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted. The energy absorbing functions may have been activated in a collision so the restraints should be examined; if the front air bags have deployed, the pretensioners have also deployed and must be replaced - regardless of whether there was an occupant in the passenger seat or not. The optional side air bags are not connected to the pretensioners. WARNING: Failure to inspect and if necessary replace the safety belt assembly under the above conditions could result in severe personal injuries in the event of a collision. Refer to Interior in the Cleaning chapter. AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) 4 3 2 H C 5 6 RPM X 1000 7 60 8 40 60 40 80 100 80 120 140 160 SCAN 4x4 F E AM/FM TAPE CD 100 180 km/h LOAD 1 20 20 MPH 120 CLOCK TUNE SEEK DISC PRO PUSH POWER VOL AUTO-M PUSH AUDIO CONT 1 4 TR/APC 2 5 RPT 3 6 TR/APC REW RDM/BS FF ON RSM LOCK SET ACC OFF CST OFF A/C MAX A/C 100