2008 Mazda RX-8 Owner's Manual - Page 190
2008 Mazda RX-8 Manual
Page 190 highlights
Driving Your Mazda Switches and Controls HomeLink should now activate your rolling code equipped device. NOTE To program the remaining two HomeLink buttons, begin with "Programming" ― step 2. Do not repeat step 1. For questions or comments, please contact HomeLink at www.homelink.com or 1800-355-3515. Continue to press and hold the HomeLink button while you press and release ― every two seconds ("cycle") your handheld transmitter until the frequency signal has successfully been accepted by HomeLink. (The indicator light will flash slowly and then rapidly.) Proceed with "Programming" step 4 to complete. qGate operator/Canadian Programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission ― which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live), replace "Programming HomeLink" step 3 with the following: NOTE If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent possible overheating. qOperating the HomeLink System Press the programmed HomeLink button to operate a programmed device. The code will continue being transmitted for a maximum of 20 seconds. qReprogramming the HomeLink system To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, proceed with "Programming" - step 2. qErasing Programmed HomeLink Buttons To erase the existing programming from all three operating channels, press and hold the two outside buttons ( , ) on the auto-dimming mirror until the HomeLink indicator light begins to flash after approximately 20 seconds. Verify that the programming has been erased when you resell the vehicle. 5-64