2009 Mazda CX-9 Owner's Manual - Page 284
2009 Mazda CX-9 Manual
Page 284 highlights
Interior Comfort Audio System (Master code input preparation) 1. Hold the scan button, then press channel preset button 4, hold both buttons together for 1.5 seconds. 2. "ENTER PIN" appears for 2 seconds which indicates that it is in code input mode. 3. "SR1 - - - -" appears, which indicates that it is ready for code input. l (How to clear the message) l Press any of the following FM/AM, SAT, CD, AUX, CAT, ESN/DISP, Instant replay, POWER buttons. l Turn the ACC off or insert a CD. NOTE l (Master code input) 4. Input the master code using the channel preset buttons 1-4. Press the scan button inputting the code. (The master code is already set at the time of factory shipment.) (Master code input determination) 5. Determine the master code which has been input by pressing the scan button. 6. "PIN CLEARED" appears which indicates that the master code input has been completed. 7. The ID code is set to the default [0000] and the initialization process is completed. NOTE Master code: The Master Code is used to initialize or reinitialize the ID code in the event that the code is not set to [0000] and/or the personalized ID code is not known. The initialization process resets the ID code to [0000]. The master code can potentially defeat the intent of the security of the parental lock if it is located by persons not authorized by the owner to access certain channels. SIRIUS Satellite Radio Master Code: [0913] l When a numeric value other than the master code is input and the scan button is pressed, "SR1 Err" is displayed and then it returns to the "SR1 - - - -" display again. If an ID code is not input for 10 seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the scan button are used for inputting the ID code. Buttons 5 and 6 cannot be used. Change of ID code Setting condition: SAT mode When changing the ID code, the new ID code is input after the previous one is input first. (Registered ID code input) 1. Hold the scan button, then press channel preset button 5, hold both buttons together for 1.5 seconds. 2. "ENTER PIN" appears for 2 seconds which indicates that it is in code input mode. 3. "SR1 - - - -" appears, which indicates that it is ready for code input. 6-44