1999 Mercury Villager Owner's Manual - Page 182

Roadside emergencies Stowing the spare 1. Lay the tire on the ground with the interior side facing up. 2. Install the retainer through the wheel center and slide the wheel under the vehicle. 3. Turn the wrench clockwise until the tire is raised to its original position underneath the vehicle. The hex nut ratchets when the tire is raised to the stowed position. It will not allow you to overtighten. 4. Check seating position of tire for looseness against the underbody supports and retighten if necessary. Ensure the position of the tire is not too far forward to avoid contact with the axle. Tire change procedure When one of the front wheels is off the ground, the transaxle alone will not prevent the vehicle from moving or slipping off the jack, even if the vehicle is in P (Park). To prevent the vehicle from moving when you change a tire, be sure the parking brake is set, then block (in both directions) the wheel that is diagonally opposite (other side and end of the vehicle) to the tire being changed. If the vehicle slips off the jack, you or someone else could be seriously injured. All occupants should be out of the vehicle while it is on the jack. 182