2007 Mercury Milan Owner Guide 1st Printing - Page 54

Lights 11. Re-apply pressure around the complete circular ring on the housing to make sure the protective cap is completely seated. 12. Reconnect washer bottle filler neck snap strap by reversing step 3 (Passenger Side Only with ABS). 13. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Lowbeam bulb replacement 1. Make sure headlamp switch is in the OFF position, then open the hood. 2. Remove the vertical shield from the bolster by disengaging the S-shaped clip and rotate it up in a clockwise direction. (Driver's side only) 3. Remove the AirTube from the air filter assembly. (Driver's side only). 4. Remove screw from oval splash shield access panel from the exterior wheel well area. Lift up and rearward to release a hidden finger attachment at the lower portion of the panel (Passenger side only with ABS). 5. From the exterior wheel well area reach arm through splash shield opening to access bulb socket (Passenger side only with ABS). 54 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)