2007 Mercury Milan Owner Guide 1st Printing - Page 86
2007 Mercury Milan Manual
Page 86 highlights
Locks and Security • the vehicle has then come to a stop and the ignition is turned to the 1 (LOCK) or 2 (ACC) position; and • the driver door is opened within 10 minutes of the ignition being transitioned to the 1 (LOCK) or 2 (ACC) position. Note: The doors will not autounlock if the vehicle has been electronically locked before the driver door is opened. Note: The autounlock feature is disabled on vehicles equipped with a manual transmission. Deactivating/activating autolock feature Your vehicle comes with the autolock features activated; there are two methods to enable/disable this feature: • Through your authorized dealer or • by using a power door unlock/lock sequence. Note: The autolock feature can be activated/deactivated independently of the autounlock feature. Before starting, ensure the ignition is in the 1 (LOCK) position and all vehicle doors are closed. You must complete Steps 1-5 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, wait a minimum of 30 seconds before beginning again. 1. Place the key in the ignition and turn the ignition to the 3 (RUN) position. 2. Press the power door unlock control on the door panel three times. 3. Turn the ignition from the 3 (RUN) position to the 1 (LOCK) position. 4. Press the power door unlock control on the door panel three times. 5. Turn the ignition back to the 3 (RUN) position. The horn will chirp one time to confirm programming mode has been entered and is active. 6. To enable/disable the autolock feature, press the unlock control, then press the lock control. The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated. 7. Turn the ignition to the 1 (LOCK) position. The horn will chirp once to confirm the procedure is complete. 86 2007 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)