2010 Nissan Sentra Owner's Manual - Page 117
2010 Nissan Sentra Manual
Page 117 highlights
WARNING ● In an accident you could be thrown from the vehicle through an open moonroof. Always use seat belts and child restraints. ● Do not allow anyone to stand up or extend any portion of their body out of the moonroof opening while the vehicle is in motion or while the moonroof is closing. ● the moonroof glass panel has been adjusted or changed, or ● the electrical supply interrupted and/or some malfunction has been detected. Use the following reset procedure to return moonroof operation to normal. 1. Press the UP/CLOSE side of the moonroof switch, until it stops and then release the switch. 2. Push and hold the UP/CLOSE side of the moonroof switch. The moonroof panel will begin to move in about 10 seconds. 3. Continue to hold the UP/CLOSE side of the moonroof switch while the panel moves in a jogging motion to the full tilt position. When the panel reaches the full tilt position it will back up a little and stop. 4. Release the UP/CLOSE side of the moonroof switch. 5. Within 5 seconds of completing step 4, press and continuously hold the UP/CLOSE side of the moonroof switch. After a delay of 5 seconds, the panel will move from the tilt position to the open position and back to the close position. 6. Release the UP/CLOSE side of the moonroof switch. Do not disconnect the power for at least 2 seconds. The moonroof is now restarted. NOTE: If the UP/CLOSE side of the moonroof switch is released anytime during the restarting process, all learned profile data will be discarded and the procedure will have to be started over. If the moonroof still does not operate properly, have the moonroof system checked, and if necessary repaired, by a NISSAN dealer. CAUTION ● Remove water drops, snow, ice or sand from the moonroof before opening. ● Do not place heavy objects on the moonroof or surrounding area. Auto-reverse function (when closing or tilting down the moonroof) The auto-reverse function can be activated when the moonroof is closed or tilted down by automatic operation when the ignition switch is placed in the ON position or for about 45 seconds after the ignition switch is placed in the OFF position. Depending on the environment or driving conditions, the auto-reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. Resetting the moonroof switch The moonroof switch may not operate properly and may need to be reset if any of the following conditions have occurred: ● the battery terminal has been disconnected, ● the moonroof has been manually moved, ● the moonroof motor has been removed and reinstalled after the moonroof has been repositioned or adjusted, 2-38 Instruments and controls