1995 Oldsmobile Aurora Owner's Manual - Page 142
1995 Oldsmobile Aurora Manual
Page 142 highlights
AMEM: Press this button to change between the AM, FM1 and FM2 bands. The display will show which band you are on. If you press this button while a tape or CD is playing, the tape or CD will stop and the radio will return to the AM or FM band that you were on. SEEK A/V:When you press SEEK while playing the radio, the radio will search for the next higher or lower station and stop. The radio will be muted while seeking. TUNE: Press lightly on this knob to release it from its recessed position. Turn it to tune in radio stations. You may push the knob back in to return it to its recessed position when not in use. To Preset RadioStations The five pushbuttons labeled 1-5 can be used to preset up to 15 radio stations (five AM, five FM 1 and five FM2). 1. Tune in the station you want to store. SCAN: When you press SCAN while playing the radio, the radio will go through each station, pausing for a few seconds at each station. Press SCAN again to stop ona station. The radio will be muted while scanning and "SCAN" will appear on the display. When you press SCAN and hold it for about two seconds until the display shows "PSCAN' (Preset Scan), the radio will scan only stations that you've preset with your radio pushbuttons. Press SCAN again to stop on a station. 2. Press TONE to select the setting that you prefer. 3. Press and hold one of the five pushbuttons until the display shows a channelnumber. The radio will mute until the channel number is displayed. Whenever you press that button again, the preset station and tone setting will return. Always check whether you're in AM, FMl or FM2. RCL (Recall): When the ignition is off, press RCL to display the time. When the radio is on, press RCL to switch the display between the radio station and the time. After five seconds the display will return to its normal display. The radio can be set so that either the time or radio station is normally displayed when the radio is playing. To do this, press RCL to display the time or radio stations as desired, then hold RCL down until the display flashes. 3-10