1999 Oldsmobile Intrigue Owner's Manual - Page 264

2. Using an E8 torx socket, turn the horizontal aiming adjustment screw (A) until the "0" (zero) on the pointer is lined up with the center marking on the horizontal block index plate (C). - Center High-Mounted Stoplamp 1. Open the trunk. 3. To adjust thevertical aim, use an E8 torx socket and turn the vertical aiming adjustment screw (B) until the bubble inside the level (D) is centered at "0" (zero). Front Parking, Sidemarker and Turn Signal Cornering Lamp 1. Remove the headlamp assembly. Refer to the removal procedure earlier in this section. 2. Remove the rubber bulb accesscover. L r 3. Twist and pull each bulb socket from the headlamp assembly. 4. Holding the base of the bulb, pull the bulbfrom the socket. 5. Push the new bulb intothe socket. 6. Put the bulb socket back into theheadlamp assembly and turn it to the right until it is secure. I 2. Reach through the access opening in the trunk. 3. Remove the bulb by turning it one-quarter of a turn to the left. Redace the rubber bulb access cover. 6-36