2001 Oldsmobile Intrigue Owner's Manual - Page 68
2001 Oldsmobile Intrigue Manual
Page 68 highlights
You can customize the vehicle to activate the Last Door Closed Locking feature as described previously or to completely disable the Last Door Closed Locking feature atall times. If disabled, the doors will lock immediately when a power door lock switch is pressed. The Last Door Closed locking featureis enabled and disabled when the doors are closed the ignition key and is in ON. Press and hold the power door lock switch in the unlock position. While holding the door unlock switch, cycle the transaxle out of and back into PARK (P). After an initial transaxle cycle, each additional cycle will toggle the enable/disable state of the Last Door Closed Locking feature. During this customization procedure, the chime will sound, providing the driver feedback. A single chime will be heard if the Last Door Closed Locking feature is disabled and two chimes will be heard if the Last Door Closed Locking feature is enabled. When the door unlock switch is released, the vehicle will remain in the most recent operating mode. The LastDoor Closed Locking feature will be enabled when the vehicle is shipped from the factory. Disconnecting the vehicle's battery for up to a year will not change the programmed mode of the Last Door Closed Locking feature. Keyless Entry System If your vehicle has this option, you can lock and unlock your doors orunlock your trunk from about 3 feet (1 m) up to 30 feet (9 m) away using the remote keyless entry transmitter supplied with your vehicle. Your keyless entry system operates on a radio frequency subject to Federal Communications Commission (FCC) Rules and with Industry Canada. This devicecomplies with Part 15of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with RSS-210 of Industry Canada. Operation is subject to the following conditions: two (1) this device may not cause interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. Changes or modifications to this system by other than an authorized service facility could void authorization to use this equipment. 2-8