2001 Oldsmobile Silhouette Owner's Manual - Page 116

Resetting the Power Sliding Door The power sliding door may operate incorrectly or not at all because of the following conditions: 4. Remove the fuse 29 from the underhood fuse block. Leave it out for 30 seconds. 5. Reinstall the fuse and wait 10 seconds. 6. Turn the power sliding door override switch on. 7. Press either of the power door lock switches to open the power sliding door. 8. Open the door. 9. Wait five seconds and close the door by pressing either power door lock switch. 10. Wait five seconds and repeat Steps 7 through 9. If the door does not rest in the fully open position after repeating Step 7, repeat Steps 7 through 9 again. If the door still does not operate correctly, see your dealer for service. D A low voltage or dead battery, D disconnecting the battery, or D if the instrument panel PWR/HEATED SEAT PSD fuse or the underhood fuse 5, 27 or 29 are removed or blown. See "Fuses and Circuit Breakers" in the Index for more information about your fuse panel. If any of these conditions occur, the power sliding door will need to be reset. If your vehicle has the optional dual power sliding doors, both doors will have to be reset. To do this, follow the directions listed here. It will be easier if you read through them once before beginning this procedure. 1. Check to be sure the power sliding door is unlocked and securely closed. 2. Turn the ignition key to OFF. 3. If on, turn off the power sliding door override switch off. Canceling the Sliding Door Security Lock 1. Unlock the sliding door and open the door from the outside. 2. Move the security lock lever all the way down. The sliding door lock will now work normally. 2-34