1999 Pontiac Montana Owner's Manual - Page 343

yellowblue Taillamps 1. Open the liftgate. 2. Remove the two screws from the taillamp housing on the inboard side. 3. Pull off the entire taillamp housing. The locator/retaining pins on the outboard side are part of the lamp assembly and will remain intact during removal. 7. To replace the lamp assembly, line up and insert the tabs on the back of the assembly with the slots in the fender. Engage the lower clip on the front of the lamp assembly, keeping the upper tab on the parking/turn signal lamp assembly inboard of the headlamp bracket tab. 8. To align the parking/turn signal lamp assembly with the headlamp assembly, lift up the parking/turn signal lamp assembly until the upper edge is contacting the fender. 9. Fasten the parking/turn signal lamp assembly to the headlamp assembly with the thumb screw removed in Step 2. 4. Remove the bulb holder by pressing the four retaining tabs and pulling the holder away from the assembly. 5. Replace the bulb(s) by pulling the old one(s) out and gently pushing the new one(s) into the bulb holder socket. 6-37