2000 Pontiac Montana Owner's Manual - Page 117

Entering Programming Mode To program features, your vehicle must be in the programming mode. Follow these steps: 1. The content theft-deterrent system (if equipped) must be disarmed. See "Content Theft-Deterrent System" in this section. 2. Remove the BCM PRGRM fuse from the instrument panel fuse block, located to the right of the glove box. (See "Fuses and Circuit Breakers" in the Index.) 3. Close the driver's door. 4. Turn the ignition key towards you to ACCESSORY. 5. Count the number of chimes you hear. You will hear two to four chimes depending on the features your vehicle is equipped with. Refer to the chart shown previously. You can now program your choices. To exit the programming mode, follow the steps listed under "Exiting Programming Mode" later in this section. Delayed Illumination and Exit Lighting With delayed illumination, the interior lamps will stay on for about 25 seconds after all the doors and the liftgate are closed. With exit lighting, the interior lamps will come on and stay on for about 25 seconds whenever you remove the key from the ignition. To customize these features to your preference, see "Programmable Modes" following. Programmable Modes Your vehicle can be programmed to one of the following modes. Mode 1: Both Features Off (The interior lamps will turn on or off at the same instant that a door is opened or closed.) Mode 2: Delayed Illumination Only (The interior lamps will stay on for about 25 seconds after all the doors and liftgate are closed, or until you lock the doors.) Mode 3: Exit Lighting Only (The interior lamps will come on whenever you remove the key from the ignition and stay on for about 25 seconds, or until you lock the doors.) Mode 4: Both Features On (This combines Modes 2 and 3.) 2-14