2001 Pontiac Montana Owner's Manual - Page 146

Resetting the Power Sliding Door The power sliding door may operate incorrectly or not at all because of the following conditions: 5. Reinstall the fuse and wait 10 seconds. 6. Turn the power sliding door override switch on. 7. Push either of the power door buttons to open the power sliding door. 8. Open the door. 9. Wait five seconds and close the door by pushing either power door button. 10. Wait five seconds and repeat Steps 7 through 9. If the door does not rest in the fully open position after repeating Step 7, repeat Steps 7 through 9 again. If the door still does not operate correctly, see your dealer for service. D A low voltage or dead battery, D disconnecting the battery, or D if the instrument panel fuse 4 or the underhood fuse 5, 27 or 29 are removed or blown. See "Fuses and Circuit Breakers" in the Index for more information about your fuse panel. If any of these conditions occur, the power sliding door will need to be reset. If your vehicle has the optional dual power sliding doors, both doors will have to be reset. To do this, follow the directions listed here. It will be easier if you read through them once before beginning this procedure. 1. Check to be sure the power sliding door is unlocked and securely closed. 2. Turn the ignition key to OFF. 3. If on, turn the power sliding door override switch off. 4. Remove fuse 29 from the underhood fuse and relay center. Leave it out for 30 seconds. Canceling the Sliding Door Security Lock 1. Unlock the sliding door and open the door from the outside. 2. Move the security lock lever all the way down. The sliding door lock will now work normally. 2-34