2001 Pontiac Montana Owner's Manual - Page 23

Replacing the Split Bench Sections Make sure the seatback is in the upright position and the safety belts are on the correct section of the seat. Don't put the sections of the bench seat in so they face rearward because they won't latch that way. If you want more storage room behind the seat, adjust each section by sliding it forward. The split benches have seat position labels, located on the back of each seat, showing where the seat must go. Follow that diagram. D The left (40) section of the 40/60 split bench uses the A and B sets of floor cups. 6. To unlatch the front latches, squeeze the angled bar toward the straight crossbar. 7. Remove the seat by rocking it slightly forward, then toward the rear of the vehicle and then pulling it out. Repeat these steps for the other section of the split bench seat. D The right (60) section of the 40/60 split bench uses the C and D sets of floor cups. the G and H sets of floor cups. D The left section of the 50/50 split bench uses D The right section of the 50/50 split bench uses the I and J sets of floor cups. See "Rear Seats" in the beginning of this section for more details. The seat must be placed in the proper location for the legs to attach correctly. Make sure the seat is in the full rear position before beginning this procedure. 1-11