2002 Pontiac Aztek Owner's Manual - Page 144

2. Insert the slide locks under the two rear floor retainers by pressing the button down and pressing them outward. You may have to apply downward pressure to the floor track assembly to engage the slide locks under the floor retainers. Double check to ensure that the slide locks are engaged under the retainers and locked into place. 3. Feed the tethered ring upward through the lower sidewall loop on each side of the vehicle. Make sure that the tethered ring is placed on the outer edge of the tailgate, on each side of the vehicle, for later attachment to the tray. 4. Push and pull on the floor track assembly to make sure it is locked into place. Replacing the Sliding Rear Convenience/Cargo Tray The floor track assembly must be installed first for the sliding rear convenience/cargo tray to stay locked into place. See "Replacing the Floor Track Assembly" listed previously for more information. 1. Pick up the tray by the handle and support the tray from the bottom with your other hand. 2. Place the tray onto the floor track assembly. Make sure that the two front axles are placed over the hooks on the rear of the floor track assembly. There are four (4) axles on the bottom of the tray (two in front and two in back). Make sure the rollers on the bottom of the tray are located in the tracks of the floor track assembly. 3. Roll the tray forward into the vehicle until you hear a click. 4. Press the release lever and pull the tray onto the tailgate. Connect the hook to the tethered ring located on each side of the sliding rear convenience/cargo tray. 5. Press the release lever and roll the tray back into the vehicle. You will hear a click when the tray is locked into position. 2-67