2006 Pontiac Montana SV6 Owner's Manual - Page 373

To use your accessory inflator system, do the following: 1. Turn the ignition to ACCESSORY or RUN. 2. Attach the appropriate nozzle adapter, if required, to the end of the hose that has the pressure gage. 3. Attach that end of the hose to the object you wish to inflate. 4. Remove the protective cap covering the outlet. 5. Attach the other end of the hose to the outlet. 6. Press the accessory inflator switch. The light in the switch will come on to show the system is working. If the accessory inflator system does not turn on or the light does not come on, the fuse may be blown or installed incorrectly. See Fuses and Circuit Breakers on page 5-98 or see your retailer for service. Your accessory inflator will automatically shut off after about 10 minutes. The light in the switch will blink. After about one minute you can use the system again. Press the switch and the indicator light will come on. Notice: If you run the accessory inflator longer than 30 minutes at a time, you could damage the inflator. The repairs would not be covered by your warranty. Run the inflator for short periods of time only. After running the accessory inflator for 30 minutes, wait at least 10 minutes before restarting the accessory inflator. To turn off the inflator, do the following: 1. Press the switch and detach the hose, first from the inflated object, then from the outlet. 2. Put the protective cap back on. 3. Place the inflator kit tools in the pouch, and store in the rear compartment on the passenger's side. To put the cover back on, line up the tabs at the bottom of the cover and put it in place. Push down the tab to secure the cover. 5-69