2008 Pontiac G6 Owner's Manual - Page 276
2008 Pontiac G6 Manual
Page 276 highlights
4. With the coolant surge tank pressure cap off, start the engine and let it run until you can feel the upper radiator hose getting hot. Watch out for the engine cooling fans. By this time, the coolant level inside the coolant surge tank might be lower. If the level is lower than the FULL COLD mark, add more of the proper mixture to the coolant surge tank until the level reaches the FULL COLD mark. 5. Then replace the pressure cap. Be sure the pressure cap is hand-tight and fully seated. When to Check Power Steering Fluid Power steering fluid is used in all vehicles with V6 engines. Vehicles with the 4-cylinder engine have electric power steering and do not use power steering fluid. It is not necessary to regularly check power steering fluid unless a leak is suspected in the system, or an unusual noise is heard. A fluid loss in this system could indicate a problem. Have the system inspected and repaired. How to Check Power Steering Fluid To check the power steering fluid, do the following: 1. Turn the key off and let the engine compartment cool down. 2. Wipe the cap and the top of the reservoir clean. 3. Unscrew the cap and wipe the dipstick with a clean rag. 4. Replace the cap and completely tighten it. 5. Remove the cap again and look at the fluid level on the dipstick The fluid level should be within the crosshatched area on the dipstick. If the fluid is at or below the ADD mark on the dipstick, add just enough fluid to bring the level within the crosshatched area. Power Steering Fluid See Engine Compartment Overview on page 5-14 for reservoir location. 5-40