2010 Pontiac Vibe Owner's Manual - Page 171
2010 Pontiac Vibe Manual
Page 171 highlights
Driving and Operating If the cruise control indicator light flashes, press the ON-OFF button once to deactivate the system, and then press the button back on. If the cruise control speed cannot be set or the cruise control cancels immediately after being activated, there may be a problem with the cruise control system. See your dealer/retailer. Resuming a Set Speed If the brakes are applied after the cruise control is set, the cruise control is turned off. If the vehicle speed is 25 mph (40 km/h) or greater, push the lever up to +RES (Resume/Accelerate) to return to the previously set speed. Increasing Speed While Using Cruise Control There are three ways to increase the vehicle speed: 8-37 Reducing Speed While Using Cruise Control There are two ways to reduce the vehicle speed while using cruise control: • Use the accelerator pedal to get to the higher speed. Move the lever down to −SET. Release the lever and the accelerator pedal. • Push and hold the lever to −SET until the desired lower speed is reached, then release it. • Move the cruise lever up to +RES. Hold it there until the desired speed is reached, and then release the lever. • To slow down in very small amounts, push the lever down briefly. Each time this is done, the vehicle will go about 1 mph (1.6 km/h) slower. Passing Another Vehicle While Using Cruise Control Use the accelerator pedal to increase the vehicle speed. When you take your foot off the pedal, the vehicle slows down to the cruise control speed set earlier. • To increase the vehicle speed in very small amounts, move the lever to +RES briefly and then release it. Each time this is done, the vehicle goes about 1 mph (1.6 km/h) faster.