2005 Saab 9-3 Owner's Manual - Page 30
2005 Saab 9-3 Manual
Page 30 highlights
28 Safety If fitting a child restraint that is intended to be secured in position by the standard safety belt, make use of the locking function of the belt. Locking the belt lessens the risk that the seat will work loose while the car is in motion. 1 Position the child restraint in the back seat. 2 Route the belt in the restraint according to the installation instruction of the restraint. 3 Pull out the belt completely until it stops. Then let the belt slowly pull in the slack. Clicking sound indicates that the lock function is in work. 4 Pull the shoulder belt tight to secure the child restraint in position. 5 Check for correct locking function by pulling on the belt. The belt must not unreel. The safety belt locking function will be deactivated when the safety belt is retracted. 1 Disengage the safety belt latch from the buckle. 2 Disengage the safety belt from the child restraint, according to the instructions from the child restraint manufacturer. 3 Let the safety belt retract until the clicking sound ceases. Installation of child restraint using the standard safety belt WARNING Failure to follow all the manufacturer's instructions on the use of child restraint systems can cause your child to strike the vehicle´s interior during a sudden stop or crash. Child restraints that are approved for rearward facing installation in the rear seat can be positioned in any of the three rear places. Make sure that it is possible to fit it in accordance with the manufacturer's instructions. When fitting child restraints in cars you must always read the instructions supplied by the child restraint manufacturer.