2005 Saab 9-3 Owner's Manual - Page 91

Instruments and controls When the engine is started, the function that was selected when the engine was switched off is displayed, with the following exceptions: • Temp is displayed if the outside temperature is between 26 and 38°F (-3 and +3°C). • D.T.E is displayed if less than or equal to 30 miles (50 km). Outdoor temperature Setting values 1 Select one of the functions using the INFO dial. • Speed W (preset to 55 mph (90 km/h) • Dist (preset to 100 miles (100 km) if not previously set) • Speed Ø • Arriv 2 Press and hold the INFO dial until given audible confirmation. 3 Turn the INFO dial to change the value. (Press CLEAR to reset the value.) 4 Press the INFO dial to finish setup. Using DIST as a trip meter 1 Select Dist using the INFO dial. 2 Press and hold the CLEAR button for approx. 1 second. An arrow will now appear on the right-hand side of the display, indicating that the trip meter is running. Resetting a single function 89 1 Select the function you wish to reset with the INFO dial. • Fuel Ø • Speed Ø • Trip (Dist used as trip meter) 2 Press and hold the CLEAR button for approx. 1 second. The selected function will now be reset. Resetting the trip computer 1 Select one of the functions using the INFO dial. • Fuel Ø • Speed Ø • D.T.E. • Arriv • Trip (Dist used as trip meter) 2 Press and hold the CLEAR button (approx. 3 seconds) until audible confirmation is given. WARNING Remember that roads can be icy even at temperatures of above 38°F (+3°C), especially on bridges and stretches of road that are sheltered from the sun. The Temp function is always activated (even in NIGHTPANEL mode) if the outdoor temperature rises or falls to between 26 and 38°F (-3 and +3°C). If the temperature sensor, located under the front bumper, is covered by snow or ice, temperature readings will be unreliable. For how to set the year, month and day, refer to Clock on page 92.