2001 Subaru Outback Owner's Manual - Page 115

Keys and doors B Passive arming When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. n To enter the passive mode WARNING Do not disconnect or tamper with any yellow connector and/or any harness covered with yellow insulation and/or tape. Doing so could result in accidental inflation of the SRS airbag or could make the SRS airbag system inoperative, which may result in serious injury. HB2036BA HB2038BB 1. Remove the side sill cover on the driver's side. 1) Open the driver's door. 2) Remove the clip by prying the edge with screwdriver. 3) Remove the side sill cover by pulling it up. 2. Connect the white (1 pole) connector. 3. Turn the ignition switch from the "LOCK" to the "ON" position. 4. Install the side sill cover. To place the system in active arming mode (remote required for activation), disconnect the white connector. - CONTINUED - 2-17