2001 Subaru Outback Owner's Manual - Page 229

Audio B Scan tuning (SCAN) Turn the tuning dial inner tuner to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned. Turn the tuning dial's inner tuner again to cancel the SCAN mode and to stop on any displayed frequency. Scan tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills. B Preset tuning Press any one of the preset buttons to select the corresponding, previously-registered radio station. The LED at the top of that button will turn on. n Manual preset D Use the tuning dial to select the radio station which you wish to register. D Choose the preset button to which you wish to assign that station and press it continuously for a period of more than 2 seconds. When the radio station has been successfully registered, the display will flash the corresponding radio frequency on and off once. NOTE D Each preset button can be used to store both an FM station and an AM station. D If the power supply is interrupted by disconnection of the battery, memory presets will be cleared and will be required to be reinput. B Weather band button (WB) Push the "WB" button when the radio is off to turn on the radio in the weather band. Press the "WB" button when the radio is on to select the weather band. - CONTINUED - 5-43