2003 Subaru Outback Owner's Manual - Page 192

B Waveband selection n FM/AM selection Push the "BAND" button 2 to select FM1, FM2 or AM reception. The display indicates which one is currently selected. n FM/AM/Weather band selection Push the "BAND" button 2 to select FM1, FM2, AM or Weather band (WB) reception. The display indicates which is currently selected. B Stereo indicator The stereo indicator "ST" will come on when an FM stereo broadcast is received. B Tuning (TUNE) n Manual tuning (TUNE) Press the tuning button 3 marked "Y" to increase the tuning frequency and press the tuning button marked "B" to decrease it. Each time the button is pressed, the frequency interval can be changed between 10 kHz in the AM mode and 0.2 MHz in the FM mode. Constant pressure on the button causes a continuous change in the frequency. n Manual tuning for weather band When weather band mode is selected, press the tuning button 3 marked "Y" to change the WB channel up and press the tuning button marked "B" to change the WB channel down. Each time the button is pressed, the WB channel changes to the next channel. Constant pressure on the button causes a continuous change in the frequency. n Automatic tuning (SCAN) Press the "SCAN" button 6 to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned from the low end to the high end. 5-8